Attention:

Please do not discharge the device too much. This may mean that the device can no longer be charged. You should charge the device at the last bar to ensure that the battery lasts.
Always use a regcharge under 1 Ampere. If not charging check the charging power.
Buy quality batteries from known brands as a replacement.

 

Technical overview:

Battery capacity 18650 3.7V 3200mah
Charger/output voltage 5.0V/1A
Charging Type-C-USB charging socket
On/Off Press the on/off button 3 times in quick succession.
Safety power duration 5 minutes and 10 minutes optional
Ceramic heating chamber with embedded heating element
OLED screen
Tempreture range 100℃-240℃(212℉-464℉)

 

OPERATING INSTRUCTIONS

Remove the mouthpiece from your Vapeble Wolke V2 to expose the heating chamber.
Always fill the chamber with moderately ground herb. Not too much plant material so that the airflow is not unnecessarily obstructed. Then reinsert the mouthpiece into the heating chamber.
Please press the power button three times in quick succession to switch on the appliance. 
The Vaporizer will start heating immediately. A coffee cup symbol flashes on the display during heating. As soon as the desired temperature is reached, the symbol stops flashing. The desired temperature has been reached.
You can set the temperature using the + button and the - button. The appliance always remembers the last temperature setting.
If you press and hold the - button and the power button for two seconds, you can choose between the temperature unit and Celsius.
If you press and hold the + button and the power button for two seconds, you can choose between 5min and 10min session duration.

Tips for vaporising:

You should grind the herbs finely, but not too finely. Dust/powder sticks together.
It is best to fill the chamber only 2/3 full so that the air can pass through.
Set the temperature low and then increase according to flavour and effect.
The herbs should have enough carrier substance. Essential oils or resins.
Change the airflow of the Wolke V2 to change the density on the vapour.

CHARGING

To protect the battery and prolong its life, it is recommended that your Vapeble Wolke V2 is charged with a suitable power supply at least 6 hours before first use.

When charging, the OELD screen lights up and the battery symbol shows the battery charge status.

Battery charge status. The battery is full when the symbol display is full.

The Vapeble Wolke V2 switches off automatically after it has been fully charged if it is not used for 60 seconds.

After using the Vapeble Wolke V2 allow the device to cool down before storing. Store the Wolke V2 vaporiser in a dry and cool place safe from the weather and out of the reach of children or unqualified persons.

 

CLEANING/MAINTENANCE

The filter and mouthpiece can be easily cleaned with alcohol.

It helps to use the enclosed brush to brush out the heating chamber after each use. The heating chamber can also be carefully cleaned every few weeks with alcohol and a cotton bud.

Regular cleaning is important so that the flavour is not impaired and the service life of the appliance is extended.

 

DO NOT clean the entire appliance with water or under water.

DO NOT splash liquid or oil into the ceramic chamber.

 

WARRANTY

You have a two-year warranty, please contact your dealer if you have any problems with your Vapeble Wolke V2. The dealer will replace the defective device.

For warranty questions and problems you can also contact us at support@vapeble.com.